LinuxScribe tips a piece up at Linux.com with inside details on the design and construction of the Apollo 11 code. There are some analogies to open source development but they are slim. MIT drafted the code — to run on the Apollo Guidance Computer, a device with less grunt than an IBM XT — it had 2K of memory and a 1-MHz clock speed. It was an amazing machine for its time. NASA engineers tested, polished, simulated, and refined the code. "The software was programmed on IBM punch cards. They had 80-columns and were 'assembled' to instruction binary on mainframes... and it took hours. ... During the mission, most of the software code couldn't be changed because it was hard-coded into the hardware, like ROM today... But during pre-launch design simulations, problems that came up in the code could sometimes be finessed by... computer engineers using a small amount of erasable memory that was available for the programs. The software used a low-level assembly language and was controlled using pairs or segments of numbers entered into a square-shaped, numeric-only keyboard called a Display and Keyboard Unit... The two-digit codes stood for 'nouns' or 'verbs,' and were used to enter commands or data, such as spacecraft docking angles or time spans for operations." Reader Smark adds, "The Google Code Blog announced today that the Virtual AGC and AGS project has transcribed the Command Module and Lunar Excursion Module code used during the Apollo 11 moon landing. The code is viewable at the VirtualAGC Google Code Page."